We finished the timber flooring in the hall yesterday including the flooring that covers the step for the stairs to sit on. The staircase that we are currently using is temporary while the finished staircase is being built.
We weren’t sure about the step when it was first built. It seemed a bit out of place, but now it is clad in timber, it looks better. We are still not totally convinced, but we are going with it for the time being. The addition of the LED lights (front and back) make it look like it is there on purpose (and not just covering up some pipework!).
This is the timber step that the new stair case will sit on. The temporary staircase has been removed so that the platform can be covered in timber flooring. The LED lights that are in the step have been snipped off – the wires have been fed through the holes and will be reconnected to the LED lights before being put back into position.
There is a floor box in the centre of the hallway. This has a couple of electrical sockets plus an ethernet socket and a controlled light connections. This means that we can put a lamp on a table in the centre of the room without cables laying across the floor. Since the light is connected to the Loxone kit, it can be controlled in exactly the same way as all the other lights in the house. The cover of the floor box is covered in timber flooring to match the floor.
The platform that the new stairs will sit on is also covered in timber flooring and this means that the temporary stairs need to be removed. You can see them on their side upstairs. The bulbs for the LED lights have been snipped allowing the cables to be fed through the holes in the timber flooring. These will then be re-jointed and the LEDs put into position.
Another view of the platform for the new staircase.